[Magic Mouse Teardown (5)] A Further Look at Touch Sensor

The back side of the flexible printed circuit board for the touch sensor. The electrode that looks like an equal mark is connected to an earthing wire. Two square wires between the two bars of the equal mark are connected to the penetration wiring from the E-shaped electrode. The longitudinal wires in the center lead horizontal signal wires to the connector electrodes.

The back side of the flexible printed circuit board for the touch sensor. The electrode that looks like an equal mark is connected to an earthing wire. Two square wires between the two bars of the equal mark are connected to the penetration wiring from the E-shaped electrode. The longitudinal wires in the center lead horizontal signal wires to the connector electrodes.

Close