[Breaking Down OLED TV] Lump of Cu Found in TV Mount [Part 7]
After breaking down the display unit of XEL-1, Sony Corp's OLED TV, the Nikkei Electronics Breakdown Team started to disassemble the TV mount.
Part of the mainboard appeared when we removed the arm connected with the cover on the back side of the TV mount and display unit. Then we found a peculiar metal part on the mainboard.
"What is this?" we thought as we removed the front face of the mount chassis. There was a block of Cu covering the entire mainboard. The Cu block was a heat dissipation unit that included a radiation fan and heat pipes.
We took out the dissipation unit and found that a number of heat radiation sheets were attached on the back side of the mainboard and the unit. For a TV, these were unusually strong measures being taken against heat. The heat density is thought to be higher because the mainboard is smaller than that used in the existing LCD or PDP TV. This must be why Sony took the measures that are rarely seen in the standard TVs.
OLED TV Breakdown Part3 (4:24)
You need Windows Media Player to play the movie.
Click the play button to watch the video.
Powered by BPtv
- [Breaking Down OLED TV] We Got Sony's OLED TV [Part 1]
- [Breaking Down OLED TV] We Found Another Box [Part 2]
- [Breaking Down OLED TV] We Watched Digital Terrestrial Broadcast [Part 3]
- [Breaking Down OLED TV] Sony's Commitment in the Instruction Manual [Part 4]
- [Breaking Down OLED TV] Drive Circuit Layout Realizes 3mm Thickness [Part 5]
- [Breaking Down OLED TV] Details of OLED Panel Exposed [Part 6]
- [Breaking Down OLED TV] 'Black Stones' on Main Board [Part 8]
- [Breaking Down OLED TV] Close Look at Ethernet Connector [Part 9]
- [Breaking Down OLED TV] High Full On/Off Contrast Ratio [Part 10]